Memory Manager

The Memory Manager program can be used to update the operating system of the data converter. All other functions of the Memory Manager are not used with the D-LOGGUSB.

Setup contains the settings which are necessary for correct communication between the PC and the D-LOGGUSB.

	Save the set interface parameters
	Using the command „Test Com“ it is possible to carry out an automatic search of the data converter for COM-interfaces supported by the Memory Manager (connection via USB) independent of any setup settings.
	Selects the default directories
	Memory Manager language selection

The remaining buttons are not applicable to the data converter.

The D-LOGGUSB data converter has the same operating system (*.frm) as the BL232 Bootloader, which can be downloaded from the homepage at http://www.ta.co.at. CAUTION: Newer operating systems are not necessarily compatible with the software already present on the PC. The homepage provides information on this.
The software on the PC should always be brought up to date before an operating system update.

It is advisable to read out any logged data before updating the operating system. All program elements required for the system update are stored in a protected storage area (boot sector) that cannot be overwritten by the data converter. This means that interrupting the operating system transfer should not cause any problems. However, the device will not operate correctly until the operating system is fully loaded. In general, an update should only be performed when the newer operating system contains changes that are required (Never change a running system!). An operating system update always represents a certain small risk.