The functional data (*.dat) created with T.A.P.P.S. from the logical circuit diagram of the drawing can be imported to the Bootloader with the Memory Manager program. The Bootloader is a device which represents the interface between PC and controller. The functional data saved on the Bootloader can be imported to the respective controller in a further step.
Import the functional data to the Bootloader with the
Memory Manager program.
The Bootloader has 7 memory slots in order to save several functional data at the same time. The functional data already saved in the Bootloader is displayed in the left column.
After selecting the requested memory slot and the source file, this functional data are imported to the Bootloader by pressing start transfer .
The functional data saved on the Bootloader can be imported to the UVR1611 either via infrared or CAN interface. This data transfer is possible in Expert operation mode. The controller must also be prepared for this, as specified below:
| display output | explanation |
| MENU | |
| - - - - - - - - - - - - - - | |
| : | |
| Data Administration ◄ | Menu for data transfer with the Bootloader |
| display output | explanation |
| DATA ADMINISTRATION | |
| : | |
| DATA ⇔ BOOTLOADER: | Backup functional data of the controller on the Bootloader |
| Upload Data: | |
| CONTR. ⇒ BOOTLD. | |
| Download Data: | |
| BOOTLD. ⇒ CONTR. ◄ | Import functional data from the Bootloader to the controller |
| display output | explanation |
| BOOTLD. ⇒ REGLER | |
| - - - - - - - - - - - - - - | |
| DATA SOURCE: Bootld. |
| Storage Point: 1 | Memory slot of the functional data on the Bootloader |
| TARGET: Controller | |
| Functional Data | Overwrite the functional data of the controller |
| Overwrite? ja | |
| Factory Settings | The functional data can simultaneously be saved as factory setting. |
| Overwritten? no | |
| : | |
| DOWNLOAD DATA | |
| REALLY START? yes ◄ | The controller switches to receipt mode. |
| display output | explanation |
| NODE: 63 |
| READY FOR DOWNLOAD | The controller is ready for data transfer
which is started by pressing the START key on the Bootloader. |
| display output | explanation |
| NODE: 63 |
| PROGRAMMING | Data transfer is carried out. |
| display output | explanation |
| NODE: 63 |
| SUCCESSFUL DOWNLOAD | The functional data was successfully loaded to the controller. |
Nach oben
navigation
suche
