Display

This window shows a table of the current measurements of the controllers connected to the Bootloader. The displayed time is that of the PC being used.
The „Display“ function is the quickest and easiest way of checking the „controller ⇒ Bootloader“ data connection.

If output 14 of the UVR1611 is set to „NETW.IP.⇒DL.: yes“, then the current measurements at the network inputs during data logging over the DL bus are displayed on an extra tab as device 2. If „NETW.IP.⇒DL.:“ „yes“ is changed over to „no“, the Bootloader must be quickly turned off and on and „Test Com“ or „Test IP“ executed.

When logging the data over the CAN bus the data for each frame are available on a separate tab for each frame. The analog and digital values are identified similarly in all frames (e.g., „sensor xx“ or „analog xx“), therefore it makes sense to give each value its own „name“ (see next section). Only the last update values are ever shown. Even when switching from one tab to the next, the current values are only shown when the next update is carried out. The time of the next update is shown at the bottom of the window.